WEEK 28: PRESENTATION DAY

Objective:

To present the complete Project in presentation day.

Procedure:

1) Test the project to make sure the project is running well.

2) Print the poster for the presentation day in A1 scale.

3) The present start on 8.30 am until 12.00 pm.

Result:

Figure 28: The poster for presentation day.

The presentation was flow well. All the question from the assessor was answer well. The presentation end on 12.00 pm.

Conclusion:

The flow in presentation day was going well as the assessor come to assess the project. All the question from the assessor about my project system, how the project flow, what the function of the component use and etc. All the question from the assessor had answer well. Thank You for everyone that come and support me in presentation day.

WEEK 27: THE COMPLETE PROJECT

Objective:

To show the complete project.

Procedure:

1) Make all the connection of overall system

2) Test the project running well.

Result:

Figure 27: The whole project.

The project is connected well from the solar to charger controller and battery. The arduino Uno is connected with rtc and relay and connected from the charger controller to the water pump. The time was set and the water pump will turn on when the present time is same as the set timer for irritation.

Conclusion:

The project is connected well and the project us running well from the charging system that charge the battery well. The timer is function well. Thus, the project is running well as the objective for the project.

WEEK 26: FLOWCHART AND BLOCK DIAGRAM

Objective:  

To built a blog diagram and flowchart.

Procedure: 

1) Know the Project system flow.

2) Know the overall of the system.

Result:

Figure 26: Show the Blog Diagram Of Overall System

The Block Diagram above show that the flow of my project. For the input, the system is power up by Solar Panel and the battery. the battery is main power of my system and solar panel is to charge the battery to maintain the battery in 12 volt. Then the process is about the system that control the whole project.  Arduino Uno is the main control and the RTC is used to control the time. The Arduino Uno control the water pump by controling the Delay that use as automatic switch. The charger controller is used for cahrging system. It control the voltage flow to the battery so that the battery can longer the time life of the battery. For the output is on the display and Water pump. The display used to display the time present and to control the timer for water pump and the water pump iis used to supply the water to the plan or to agriculture area.

Figure 26.1: The Flow chart of System.

The figure above show that the flow chart of the system. This show that the whole of system from step by step and show how the flow of the system.

Conclusion:

For the conclusion, The Blog Diagram and the Flow Chart is to show the flow of my system from the the first until the end of the system flow.